|
|
|
|
Home / Computers / Computer Certification
Cisco CCNP / BCMSN Exam Tutorial: Dynamic Trunking Protocol (DTP)
By:Chris Bryant, CCIE #12933
When you're studying to pass the BCMSN exam on the way to earning your CCNP certification, you're going to add to your CCNA knowledgebase every step of the way. Nowhere is that more than configuring a trunk between two switches.
You know that IEEE 802.1Q ("dot1q") and ISL are your two choices of trunking protocols, and you know the main differences between the two. What you might not have known is that there's a third trunking protocol that's running between your Cisco switches, and while it's a transparent process to many, you had better know about it for your BCMSN and other CCNP exams!
The Cisco-proprietary Dynamic Trunking Protocol (DTP) actively attempts to negotiate a trunk link with the remote switch. This sounds great, but there is a cost in overhead - DTP frames are transmitted every 30 seconds. If you decide to configure a port as a non-negotiable trunk port, there's no need for the port to send DTP frames.
DTP can be turned off at the interface level with the switchport nonegotiate command, but as you see below, you cannot turn DTP off until the port is no longer in dynamic desirable trunking mode. (Dynamic desirable is the default mode for most Cisco switch ports.)
SW2(config)#int fast 0/8
SW2(config-if)#switchport nonegotiate
Command rejected: Conflict between 'nonegotiate' and 'dynamic' status.
SW2(config-if)#switchport mode ?
access Set trunking mode to ACCESS unconditionally
dynamic Set trunking mode to dynamically negotiate access or trunk mode
trunk Set trunking mode to TRUNK unconditionally
SW2(config-if)#switchport mode trunk
SW2(config-if)#switchport nonegotiate
When you're working with Cisco switches in a home lab or rack rental environment, run IOS Help regularly to see what options are available for the commands you're practicing with. Cisco switch ports have quite a few options, and the best way to find them is with one simple symbol - the question mark!
Article Source: http://www.dailynewarticles.com
Chris Bryant, CCIE #12933, is the owner of The Bryant Advantage, home of free CCNP and CCNA tutorials, The Ultimate CCNA Study Package, and Ultimate CCNP Study Packages.
For a FREE copy of his latest e-books, “How To Pass The CCNA” and “How To Pass The CCNP”, just visit the website! You can also get FREE CCNA and CCNP exam questions every day! Pass the CCNP exam with The Bryant Advantage!
More Articles from Computer Certification Category:
Cisco CCNP Certification / BCMSN Exam Tutorial: Writing QoS Policy
Cisco CCNP / BCSI Exam Tutorial: Configuring EIGRP Packet Authentication
Cisco CCNP / BSCI Certification: Introduction To ISIS Terminology
What To Expect When Taking Your First Cisco Certification Exam
Cisco CCNA / CCNP Home Lab: Why You Need An ISDN Simulator
Be Certifiable! The Basics Of MCSE And MCP
Cisco CCNP / BCSI Exam Tutorial: Broadcasts And The IP Helper-Address Command
Webroot Window Washer
Cisco CCNA / CCNP Home Lab Tutorial: Using 2520 Routers
CCNA / CCNP Home Lab Tutorial: The VLAN.DAT File
Cisco CCNP / BCMSN Exam Tutorial: Changing Root Bridge Election Results
CCNP Certification / BCMSN Exam Tutorial: HSRP MAC Addresses And Timers
Cisco CCNP / BCMSN Exam Tutorial: Switches, QoS, And Cisco's Networking Model
Cisco CCNA Exam Tutorial: Troubleshooting Directly Connected Serial Interfaces
How To Earn Cisco’s Firewall Specialist Certification
|
|
